3.0TFSI Supercharger Pulley Install Kit by APR Tuning

The factory Gen 1 supercharger drive pulley is pressed onto the supercharger’s input shaft. It’s not possible to remove the factory pulley without damage, or damaging the supercharger itself unless special care and attention are taken.

The APR Supercharger Drive Pulley Installation Kit is designed to encapsulate the entire pulley and pull evenly across its entire surface. The unit is compact enough to not require complete removal of the front end of your vehicle, reducing labor time. Furthermore, a provision was made to incorporate a 1/2 inch drive breaker bar which allows the entire assembly to be easily counter-held and ultimately makes the process a one-man job.

A complete install manual covers the install process from start to finish, making installation easily completed at any APR dealer or in your own garage.

Features

• Makes removing your factory pulley simple!

Please Note: This kit works only with the 3.0TSFI engine.

Applications

• 2010-2016 Audi S4
• 2010-2017 Audi S5
• 2013-2017 Audi Q5

What’s In The Box?

• 2 – Half-moon rings
• 1 – Block
• 1 – Tube of fastener assembly fluid
• Mounting hardware

References

• Installation Instructions

Warranty

• All APR Tuning items are warranted to be free from defects in the materials and workmanship prior to installation. Warranty is only applicable to the original owner. This warranty does not cover labor, misuse, faulty installation, failure of related parts or parts purchased other than from APR, LLC. Please call for specific warranty information on each product. For any questions regarding your APR warranty email [email protected].